Wifi Shield Module CC3000 For Arduino Mega2560 R3
- Buy 3 for PKR3,940.00 each and save 5%
- Buy 10 for PKR3,820.00 each and save 8%
- Buy 50 for PKR3,735.00 each and save 10%
This CC3000 Arduino shield Integrated a onboard LDO, a chip Antenna, and a level logic shifter. It works fine with Arduino or Arduino compatible main board. It uses SPI for communication so you can push data as fast as you want or as slow as you want.
It has a proper interrupt system with IRQ pin so you can have asynchronous connections. It supports 802.11b/g, open/WEP/WPA/WPA2 security, TKIP & AES. A built in TCP/IP stack with a “BSD socket” interface supports TCP and UDP in both client and server mode, with up to 4 concurrent socket connections.
- Based on TI CC3000 WIFI module.
- Use SPI communication .
- Integrated 3.3V regulator .
- Level shifter integrated .
- Integrated ceramic antenna .
- It has a connector for external antenna WIFI
- Compatible with Arduino UNO, Mega, Leondardo & Micro
- Antenna: Onboard Ceramic
- MicroSD card slot onboard
- Reset button
- Communication Protocol: SPI
- Connects via IEEE 802.11 b/g networks
- Tx Bandwidth: 11Mbps
- Tx Sensitivity: +/-18dBm
- Rx sensitivity: -86dBm
- IRQ pin for interrupts (useful for asynchronous connections)
- Supports WEP, WPA, WPA2, TKIP and AES
- TCP and UDP Client & Server Modes available
- Max Concurrent TCP/UDP Sockets: 4
- TCP/IP stack is built in.
- 1 X Wifi Shield Module CC3000 For Arduino Mega2560 R3
|Manufacturer||Made in China|
|Load Cell (kg)||NA|
|Temperature Range (Min)||-20°C|
|Temperature Range (Max)||70°C|
|Num of Pin's||NA|
|Size (mm)||6 cm X 5.3 cm X 2.4 cm|