We use cookies to make your experience better.
To comply with the new e-Privacy directive, you agree to the privacy policy and our use of cookies.
SD RAMPS Breakout Board For 3D Printer Reprap 1.4
SKU
MD-00476
PKR 450.00
The SD RAMPS is an add-on board for the RAMPS electronics that allows the user to print from a micro SD card.
📦 Pre-Order Queue:
0 Units
⚠ Available on Backorder (In 15-30 business days)
- Buy 3 for PKR 425.00 each and save 6%
- Buy 10 for PKR 415.00 each and save 8%
- Buy 50 for PKR 405.00 each and save 10%
Categories: 3D-Printers, Parts & Accessories
Ever wanted to run your RepRap from an SD card. The SD RAMPS is an add-on board for the RAMPS electronics that allows the user to print from a micro SD card. The SD RAMPS easily plugs into RAMPS version 1.3 and 1.4. It is also compatible with earlier RAMPS versions but requires some changes to the RAMPS board.
This RAMPS add-on enables you to print from MicroSD.With RAMPS 1.3 and higher it's easily connected to the RAMPS board.You will be able to print without being connected to your PC.
SPECIFICATIONS:
- SPI mode
- Support voltage:4.5 to 5.5V
- Up to 50 MB/sec data transfer rate
- Sits directly on a RAMPS
- Also be used with other microcontrollers
- Assembled SD RAMPS board
- Compatible with all RAMPS electronics version
- Requires a not included micro SD card
BLOCK DIAGRAM:
RELATED DOCUMENTS:
HOW TO USE WITH BOARD:
PACKAGE INCLUDES:
- 1 X SD RAMPS Breakout Board For 3D Printer Reprap 1.4
| Weight (KG) | 0.020000 |
|---|---|
| Manufacturer | Made in China |
| Voltage (Min) | 4.5V |
| Voltage (Max) | 5.5V |
| Output Voltage | NA |
| Power | NA |
| Current (A) | NA |
| Frequency | NA |
| Load Cell (kg) | NA |
| Output Type | NA |
| Range | NA |
| Temperature Range (Min) | -40°C |
| Operating System | NA |
| Resistance Value (Ohm) | NA |
| Baud Rate | NA |
| Interface | NA |
| Num of Pin's | NA |
| Diameter | NA |
| Size (mm) | NA |
Log In