Nordic: NRF5340 Development Kit with Bluetooth 5.2 - NRF5340-DK
- Buy 3 for PKR21,470.00 each and save 5%
- Buy 10 for PKR20,792.00 each and save 8%
The nRF5340 DK is the development kit for the nRF5340 SoC, containing everything needed to get started with development, on a single board.
The DK supports development with an extensive range of wireless protocols. It supports Bluetooth® Low Energy and all Bluetooth 5 features, including Long Range, 2 Mbps and Advertising Extensions. Mesh protocols like Bluetooth mesh, Thread and Zigbee can be run concurrently with Bluetooth LE, enabling smart phones to provision, commission, configure and control mesh nodes. NFC, ANT, 802.15.4 and 2.4 GHz proprietary protocols are also supported.
The DK is bundled with an NFC antenna that quickly enables testing of nRF5340’s NFC-A tag peripheral. A SEGGER J-Link debugger is on the board, enabling full-blown programming and debugging, of both the nRF5340 SoC and external targets.
All analog and digital interfaces, and GPIOs are available via headers and edge connectors. The kit is Arduino Uno Rev3 hardware compatible, meaning it can be easily interfaced with external device shields, including the Power Profiler Kit.
Four buttons and four LEDs simplify input and output to and from the nRF5340 SoC, they are all user-programmable. An on-board external memory is connected to the 96 MHz QSPI peripheral in the nRF5340 SoC.
The DK is typically powered with USB, but can be powered by a wide range of sources, within the supply range of 1.7 to 5.0 V. In addition to USB, it can be powered with external source, but also includes a CR2032 battery holder and a Li-Po battery connector, for in-field testing. Current consumption can be measured by using the dedicated current measurement pins.
The nRF Connect SDK is the software development kit for the nRF5340 SoC, and it has board support for the nRF5340 PDK. It offers a complete solution integrating the Zephyr RTOS, protocol stacks, application samples and hardware drivers.
Hardware layout and schematics for the nRF5340 PDK are available under Downloads.
Download nRF5340 DK product brief [PDF]
Key features
- Supports Bluetooth LE, Bluetooth mesh, NFC, Thread and Zigbee
- User-programmable LEDs(4) and buttons(4)
- 2.4 GHz and NFC antennas
- SWF RF connector for direct RF measurements
- On-board SEGGER J-Link debugger/programmer
- Arduino Uno Rev3 form factor
- Pins for measuring power consumption
- 1.7-5.0 V supply from USB, external, Li-Po battery or CR2032 coin cell batter
| Part Number | NRF5340-DK |
|---|---|
| Manufacturer | Nordic Semiconductor |
| Weight (KG) | 0.050000 |
| Memory | NA |
| Product Availability | In Stock |
Log In